Mellerware TRENTO 1200W User Manual download pdf (Page 4)

USING IT FOR THE FIRST TIME

• When first using this brewer, please carry out

a cleaning proceedure before it is pre-heated:

fill the container with water to the level marked

MAX, tighten the filter in place of brewer; turn

the switch to brewing mode . At the same

time, place an adequate container under the

filter holder and make sure the two brewing

spouts are over the container. Now, you can

hear the motor of the pump rumbeling. Water

may take a while to come out of the spout if

you are using it for the first time, or if it has

not been used for some time. The cleaning

procedure is completed when half the water is

left in the container. now you can proceed to

the pre-heat proceedure.

PRE-HEATING THE COFFEE MACHINE

• For the proper function as well as longer life in

using the coffee brewer, remember to fill with

water before the heater mode of the boiler

is turned on: by turning the selector switch to

brewing mode , and wait until water drips

out from the spout.

• For optimum pre-heating the selector switch

can be left in the heater mode for

approximately half-an-hour before making

any coffee, as long as the filter holder is firmly

attached to the appliance (make sure the

steam release knob is closed).

• To install the filter properly, simply hold the filter

handle, flip handle clip backward and place it

level under the heater. Align the filter holder so

that the handle is pointing directly in fornt of

the heater. Now rotate the handle from left to

right until it is tight.

NOTE:

* Although the optimum pre-heating time for the

machine is 10 minutes when the selector is

in the heater mode , the machine can be

operated after two minutes once the OK light

is lit.

* Fix the filter as tight as possible in the

installation to avoid water leaking from the filter.

HOW TO PREPARE ESPRESSO COFFEE

FILLING THE WATER TANK:

• To remove the water tank simply pull upwards

and fill the tank at the sink. Do not exceed the

MAX level on the water tank. The tank may also

be filled without removing it, simply by pouring

water into it directly from a jug.

• Replace the tank by connecting the valve at

the bottom of the tank with the hole in the base

of the machine.

NOTE: Do not operate the appliance without water

in the tank and always remember to fill the tank

when the water level goes below the MIN level.

The brewing of espresso requires several

attachment to be placed in the coffee filter. The

general operations are described as below:

2-cups coffee (with ground coffee)

a. Make sure the sealing ring has been placed in

the filter holder before fitting the 2-cups filter

basket;

b. Fill in the filter basket with appropriate amount

of ground coffee (12g recommended) and

follow general brewing procedures.

c. After brewing, grip the filter handle and

pressure reducer

firmly (hold for 5

seconds) when

removing the

filter holder, so

that the pressure

remaining in the

filter will be release

and the filter can

be removed safely.

NOTE:

* Please check if

the sealing ring

has been placed

properly in the

coffee filter before

fitting in the coffee filter basket.

* After brewing, remember to grip the pressure

reducer together with the filter handle firmly

when removing the filter so as to avoid the

danger of accidental pressure release.

* Every time after brewing, remember to clean

your coffee filter for hygene and for preventing

the coffee grounds from blocking the hole of

the reducer.

1-cup coffee (with ground coffee)

a. Make sure the one cup pressure valve

attachment has been placed in the filter holder

before fitting in the one cup filter basket;

b. Fill in the filter basket with appropriate amount

of ground coffee (6g recommended) and

follow general brewing procedures.

c. After brewing, grip the filter handle and

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Mellerware TRENTO 1200W User Manual Page 4

Comments to this Manuals

Related products and manuals for Coffee makers Mellerware TRENTO 1200W