Mellerware PALERMO 29002 User Manual download pdf (Page 7)

3. Place the permanent filter into the

filter holder(Fig. 1) and fill it with

espresso coffee powder, according

to your requirement by using the

measuring spoon (marked with 2

and 4 cups)(Fig. 11) and tap down

the coffee powder. This compresses

the coffee for stronger flavour. If there

is any excessive coffee power on the

top rim, scrape it off.

4. Assemble the filter holder into the

espresso side of the coffee maker by

aligning the handle with the

“ “ mark. Move the handle once in

position, so that it is aligned with the

“LOCK” mark. Ensure that it is closed

securely. (Fig. 12)

5. To control the strength of the brew,

turn the strength control knob to

your desired position (“STRONG”,

“LIGHT” or “STEAM” function) (see

Figure C & 13), depending on your

own taste or requirement.

Note: If the “STEAM” function is selected

the water will not flow through the

espresso section but rather convert

the water to steam after a few

minutes.

6. Place the small jug on the removable

drip tray and ensure the centre of

the lid aligns with the spout of the

filter holder (Fig. 14), then press the

switch on the espresso side to the

“I” position and the indicating light

will be illuminated. Brewed espresso

coffee will begin flowing into the

small jug after approximately 3

minutes.

Note: to avoid any splashing, do not

detach the filter holder while brewing

coffee.

7. Once the brewing has been

completed, press the switch to the

“O” position, remove the small jug

from the drip tray and dispense

coffee into cups. Now you can enjoy

your homemade espresso coffee.

8. Before removing the filter holder,

always release the pressure in the

boiler unit by carefully turning steam

control knob in an anti-clockwise

direction. CAREFUL! Steam will

escape from steam nozzle. Once

the pressure is completely released

and filter holder has cooled down,

remove the filter holder by turning it

anti-clockwise to the “ “ (Fig. 15).

Be sure to close the steam control

knob by turning it in the clockwise

direction until securely shut.

9. To clean the espresso filter turnover

the filter lock, then press it with your

thumb to secure the filter. Tilt the filter

holder and tap it over the rubbish

bin, then clear out the coffee residue

(Fig. 16). Wash the filter holder and

filter in fresh water and reassemble it

correctly.

Note: return filter lock to original position

before reattaching the filter holder.

ATTENTION: HOT SURFACE

The filter holder may be hot during

operation, to remove the filter holder,

turn the filter to the left, until the filter

holder dislodges from the coffee maker.

The metal parts might still be hot and

can be cooled down by running cold

water over it.

MAKE CAPPUCCINO COFFEE

Cappuccino is made by adding fresh

cream or frothed milk to the cup of

espresso coffee.

1. First prepare espresso coffee

according to the steps (1-6) above

and, ensure that the steam control

knob has been turned off and turn

the brew strength control knob

to the “STEAM” position (Fig.C).

After turning the switch on “I”,

wait approximately 3 minutes

for the coffee maker to generate

enough steam to froth the milk.

Before generating steam, fill a cup

(preferably a straight walled cup)

with about 150 ml of milk (preferably

2% milk for the best results) for each

cup of cappuccino. Lift up the cup to

MW_EX29002_Palermo_IM.indd 7MW_EX29002_Palermo_IM.indd 7 10/29/2008 12:05:32 PM10/29/2008 12:05:32 PM

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments